Central Valve, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
The central valves are attached to the impact member under the bumper cover in the rear.
-- Remove The Rear Bumper Cover. Refer to REAR BUMPER COVER, REMOVING AND INSTALLING .
WARNING:
Always Wear Safety Goggles!
NOTE:
The DRC lines must be extracted before disconnecting them from the central valve. Refer to DYNAMIC RIDE CONTROL (DRC), DRAINING AND FILLING .
Perform this step on both wiring harnesses on the central valve.
-- Remove the union bolts -2-.
-- Unscrew the bolts -1 and 3- and remove the central valve -4-.