Overview - Air Supply Unit: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Bracket
- Entire air supply unit to spare wheel well
- Removing and installing. Refer to AIR SUPPLY UNIT WITH BRACKET, REMOVING AND INSTALLING .
- Clip
- Intake Line with Filter
- Removing and installing. Refer to INTAKE LINE WITH FILTER, REMOVING AND INSTALLING .
- Air Line
- Between solenoid valve block and air supply unit
- Air lines overview -Item ) ELECTRICAL COMPONENT LOCATIONS OVERVIEW
- For the air line connecting piece tightening specification. Refer to OVERVIEW - AIR LINES .
- Line Connector
- Bracket
- Air Supply Unit with Level Control System Solenoid -N111-
- Removing and installing. Refer to AIR SUPPLY UNIT, REMOVING AND INSTALLING .
- Level Control System Solenoid -N111-, Removing and Installing. Refer to Level Control System Solenoid -N111-, REMOVING AND INSTALLING .
- If the air supply unit was replaced, then the Level Control System Compressor Relay -J403- must also be replaced. Installed location. Refer to the Appropriate Wiring Diagrams.
- Threaded Sleeve
- 7.5 Nm
- Quantity: 4
- Spring
- Quantity: 4
- Rubber Bushing
- Quantity: 4
- Bracket
- Bolt
- 9 Nm
- Air supply unit to retainer
- Quantity: 3
- Nut
- 9 Nm