Right Flange Shaft, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
- The transmission is installed.
-- Remove the right drive axle. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Remove the right drive axle heat shield. Refer to DRIVE AXLE, REMOVING AND INSTALLING .
-- Place the :SMN372500 under the transmission.
-- Remove right flange shaft by fastening :T10037 to transmission housing -arrow-.