Right Seal, Replacing: Removing
WARNING: This page is about a different car, the 2018 Audi A6, 2017 Audi A6, and 2016 Audi A6. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission is installed.
- General repair instructions. Refer to SAFETY PRECAUTIONS .
-- Remove right front wheel.
-- Remove the rear noise insulation -2-. Refer to UNDERBODY TRIM PANEL .
-- If equipped, remove the noise insulation -1- in the right wheel housing.
-- Remove the bolts -arrows- and remove the heat shield from the right drive axle.
-- Remove the right drive axle on the transmission and lay it aside. Refer to DRIVE AXLE .
-- Place the :VAS6208 under the transmission.
-- Remove right flange shaft by fastening :T10037 to transmission housing -arrow-.
-- Pry out the flange shaft seal.