LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Latch Release Lever, Removing And Installing >> Release Lever Cover, Removing And Installing

Release Lever Cover, Removing And Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA55-10709Courtesy of AUDI OF AMERICA, LLC
  1. Operating Lever
  2. >>A-Pillar<< Lower Trim
  3. Clip
    • Press in completely, it must engage.
  4. Release Lever Cover
    • First disengage the cable from the coupling inside the engine compartment. Refer to RELEASE CABLE, REMOVING AND INSTALLING  - Release Cable Coupling.
    • Pry the clip out of the release lever.
    • Remove the cover sideways from the release lever.
scientia non olet · About LEMON Manuals