LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1012 (Exterior System (Hood & Lids - Service Information)) >> 55 Hood, Lids >> Hood >> Gas-Filled Strut, Removing And Installing >> Removing

Gas-Filled Strut, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the lid or secure it against falling.

-- Using a small screwdriver, lift the securing spring -arrow- slightly and remove the gas-filled strut -1- from the upper ball stud -2-.

GWWA55-10323Courtesy of AUDI OF AMERICA, LLC

-- Repeat procedure on lower ball stud.

scientia non olet · About LEMON Manuals