Rear Window Wiper Blades, Checking

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Warning information for the high voltage system:

For procedures where the ignition must be switched on, refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED ON .

For procedures where the ignition must be switched off, refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED OFF .

-- Switch on the ignition.

-- Activate the "Rear wiper" and let the wiper arm to run to end position.

-- Turn off ignition.

-- Vehicles with ignition lock: Remove the key.

-- Check whether blade points rest in with the following distance to lower edge of window.

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 19 + 5 mm.

-- Check the adjustment of the wiper arm again and correct if necessary.

-- Adjust the windshield wiper arm. .