Adjust the Rear Window Spray Nozzle
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- If the wiper spray nozzle Adjustment Tool :T40187 is not going to be used, then make sure both sides are covered and locked with the covers -3- and -4-.
- If one side is not locked by the cover, it is possible to get injured by the Needle :3125/5 A -1- or by the adjusting pin -2-.
- When opening a side make sure the opposite side is not facing the hand.
-- Unlock the short cover -1- on the wiper spray nozzle Adjustment Tool :T40187 - -arrow A- and push it toward the rear -arrow B-.
-- Adjust spray jets with Washer Jet Adjuster :T40187 so fluid sprays over the wiper onto the rear window at the places shown.
- Make sure that the the exterior water jet directly touches the windshield when the windshield wipers are in the neutral position.
-- If the spray field does not match the specifications, clean uncleaned washer jets. .