Checking Battery And Battery Terminals For Secure Fit, All Vehicles Except Hybrid
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Warning information for the high voltage system:
For procedures where the ignition must be switched off, refer to PROCEDURES FOR WHICH THE IGNITION NEEDS TO BE SWITCHED OFF .
If the battery clamp is not seated securely on the positive terminal, disconnect the battery ground strap on the battery negative terminal first to prevent possible accidents.
-- Check the battery terminals -1- and -2- for secure fit; tighten the nuts if necessary.
-- Make sure the battery is secure. Tighten the bolts -arrows- on the battery tray -3- and on the securing bracket -4-.
| Tightening specification | Nm |
|---|---|
| Battery terminal to battery pole | 6 |
| Bolt on the bracket and battery tray | 18 |