Wheel Bearing Housing Bonded Rubber Bushing, Replacing, AWD Vehicles And E-Tron: Installing
-- Place the front bonded rubber bushing in the : T40184/3 . The "thin" collar -arrow- must face upward.
- In order to install the front rubber bonded bushing, the :T40184/2 -3- must be mounted on the front rubber bonded bushing in such a way so that the lugs -2- fit into the grooves -4-.
-- Press the front rubber bonded bushing all the way onto the thrust plates -1 and 6-.
- :VW401 . Arrange as illustrated.
- :T40184/3
- Front bonded rubber bushing
- :VW408A
- :T40184/2
- :VW402 . Arrange as illustrated.
-- Then slightly pull apart the thrust plates -1 and 6-.
-- Press the front rubber bonded bushing approximately 2 mm out of the :T40184/3 .
a = 2 mm
-- Remove the :VW408A and insert the :VW411 .
-- Position the wheel bearing housing on the :VAG1290A .
-- Mount the front rubber bonded bushing (not shown in the illustration), the pressure plate -3- and the sleeve -1- on the wheel housing bearing.
- :T40184/3
- :VW411
- :T40184/2 Pay attention to the installation position of the front rubber bonded bushing.
-- Place the tools on the front bonded rubber bushing and the wheel bearing housing -3- as illustrated.
When mounting the wheel bearing housing onto the :T40184/1 be careful not to damage or push the rubber grommet on the rear rubber bonded bushing.
-- Slowly press the front rubber bonded bushing in (not shown in the illustration) until the sleeve -2- can be pulled out at the top.
- :VW411
- :T40184/3
- Wheel bearing housing
- :T40184/1 . The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the groove on the :T40184/1 .
- :VW402
-- Install the front bonded rubber bushing -2- using :T40184/2 -1- slowly until it is flush with the edge -arrow- of the wheel bearing housing.
Ignore Item -3-.
-- Install the wheel bearing housing. Refer to WHEEL BEARING HOUSING, REMOVING AND INSTALLING, FWD VEHICLES, EXCEPT E-TRON .