General Information, Carbon-Ceramic Brake Wear Tester : Vas6813

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

This Is A New Test Procedure To Determine The Wear Limit Of The Ceramic Brake Rotors

The Brake Rotor Can Be Identified By The Following Points:

the wear indicators -arrow- on the friction surface of the brake rotor are no longer present

Courtesy of AUDI OF AMERICA, LLC
at the printed marks -A through D-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Check Occurs By Determining The Brake Rotor Thickness "And" The Wear Value With The :VAS6813 , both must be measured three times respectively around the circumference.

On The Brake Rotor Cup The Permitted Minimum Thickness "min.Th." Of The Brake Rotor Is Engraved.

On the brake rotor cup the wear value -C- of the brake rotor for the :VAS6813 is engraved.

Value -A- is a value from the production of the new brake rotor

The values -A and C- can be different depending on the location.

The values -A and C- can be different depending on the brake rotor.

Example of min.Th. -3-, brake rotor thickness. It must not fall short of this value.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Value -3- Can Be Different Depending On The Brake Rotor.