General Information, Brake Rotor Wear

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Carbon-Ceramic Brake Wear Tester :VAS6813

NOTE:

The Check Occurs By Determining The Brake Rotor Thickness "And" The Wear Value With The :VAS6813 , Both Must Be Measured Three Times Respectively Around The Circumference.

The permitted minimum thickness of the brake rotor with "min.th" as well as the wear limit -C- for the :VAS6813 are engraved on the brake rotor cup.

Courtesy of AUDI OF AMERICA, LLC

The Wear Value -C- Is Different Depending On The Brake Rotor And The Measurement Location.

NOTE:

If the brake rotor thickness "min.th." falls short at one measuring point the brake rotor must be replaced. Refer to BRAKE ROTOR THICKNESS, CHECKING .

"or"

if during the check with the :VAS6813 one of the three wear values -C- is reached or falls short the brake rotor must be replaced. Refer to CHECKING WITH Carbon-Ceramic Brake Wear Tester .

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Wear Value -C- Is Different Depending On The Brake Rotor.

If there is abrasion both brake rotors on both sides of the axle must always be replaced.