Carbon-Ceramic Brake Wear Tester: Vas6813, Checking
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Carbon-Ceramic Brake Wear Tester :VAS6813
"Before" the measurement the :VAS6813 must be checked using the supplied measurement plate.
Measurement Plate:
-- Place the measuring device in both openings of the measurement plate, -arrows- so that the laser beam points under the mark with the attached reference value.
-- Switch on the measuring device.
The Value Displayed On The Display Must Correspond To The Reference Value Attached To The Measurement Plate.
NOTE:
If The Difference To The Reference Value Is More Than ± 2.0 Units The Measuring Device Must Be Calibrated By A Specialist Company.
For More Information Refer To The Supplied Owner's Manual.