LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (1.8L - Turbo Engine Controls - Generic Scan Tool, Engine Code(S): AMB) >> ST - Generic Scan Tool >> Diagnostic Trouble Code (DTC) tables >> SAE P1xxx-DTCs >> Transmission 01V

Transmission 01V

WARNING: This page is about a different car, the 2006 Audi A4, 2005 Audi A4, 2004 Audi A4, 2003 Audi A4, and 2002 Audi A4. However, it is still accessible from the selected car via links, so may be relevant.
DTC Error Message Diagnostic Procedure Malfunction Criteria and Threshold Value Secondary Parameters with Enable Conditions Monitoring Time Length Frequency of checks, MIL Illum
P1560 Engine Overspeed Condition Engine speed > threshold, > 7400 rpm In D, 4, 3, 2 position 100 mS Yes, 2 DCY
P1745 Voltage supply for solenoid valves Short circuit to B+ Switch off, V too high > 0.8 * U Batt 30 mS Yes, 2 DCY
P1747 Voltage supply for solenoid valves Open circuit/short circuit to Ground (GND) Switch on, V too low 2.5 V 30 mS Yes, 2 DCY
P1748 Internal Control Module Memory Check Sum Error TCM internal hardware watchdog detects fault --- 100 mS Yes, 2 DCY
P1750 System Voltage, Low Voltage
  • Voltage, U 9 V
  • Ignition range out of range, 7.0 V U 9.0 V
  • Engine speed, > 1600 rpm
  • 0.14 Seconds
  • 2500 mS
 Yes, 2 DCY
P1751 System Voltage High Voltage Ignition supply out of allowable range, U > 16 V and U 7 V Engine speed, >1400 rpm 300 mS Yes, 2 DCY
P1814 Pressure control valve -1- for auto. transmission -N215- Open circuit/short circuit to Ground (GND) PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 70 mS Yes, 2 DCY
P1815 Pressure control valve -1- for auto. transmission -N215- Short circuit to B+ PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 70 mS Yes, 2 DCY
P1819 Pressure control valve -2- for auto. transmission -N216- Open circuit/short circuit to Ground (GND) PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 50 mS Yes, 2 DCY
P1820 Pressure control valve -2- for auto. transmission -N216- Short circuit to B+ PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 50 mS Yes, 2 DCY
P1824 Pressure control valve -3- for auto. transmission -N217- Open circuit/short circuit to Ground (GND) PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 50 mS Yes, 2 DCY
P1825 Pressure control valve -3- for auto. transmission -N217- Short circuit to B+ PWM should toggle, but held to 0-100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V 50 mS Yes, 2 DCY
P1829 Pressure control valve -4- for auto. transmission -N218- Open circuit/short circuit to Ground (GND) PWM should toggle, but held to 100% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V
  • 70 mS
  • 500 mS
 Yes, 2 DCY
P1830 Pressure control valve -4- for auto. transmission -N218- Short circuit to B+ PWM should toggle, but held to 0% Ignition voltage, >9.0 V or current and voltage, >500 mA, 7V
  • 70 mS
  • 500 mS
 Yes, 2 DCY
P1841 Engine control module/Transmission Control Module (TCM) Versions not compatible --- --- 0 mS Yes, 2 DCY
P1850 Data-bus-drivetrain missing message from engine control module No network token for 850 mS --- 1000 mS Yes, 2 DCY
P1854 Data-Bus-driving gear Hardware faulty No CAN bus activity for 30 mS --- 1000 mS Yes, 2 DCY
P1855 Data-Bus-driving gear Software version monitoring CAN level not correct --- 100 mS Yes, 2 DCY
P1861 Throttle Position (TP) Sensor -G79- Malfunction indication from Engine Control Module (ECM)
  • Check the Throttle Position (TP) Sensor G79. Refer to → Throttle Position (TP) Sensor G79/Accelerator Pedal Position Sensor 2 G185 , checking (Engine Code AMB)  .
 Fault flag is transmitted, fault flag set --- 400 mS Yes, 2 DCY
scientia non olet · About LEMON Manuals