Pistons, Removing And Installing: Removing

• Engine is secured to the Engine and Gearbox Bracket VAS6095A. Refer to ENGINE, SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .

-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Mark the installed position and to which connecting rod bearing cap and cylinder and the connecting rod it belongs for installing again later. Refer to Figure.

-- Remove the connecting rod bearing cap.

-- Remove the piston and connecting rod upward.

-- Remove the locking ring from the eye of the piston bolt.

-- Remove the piston pin using the Pilot Drift VW222A.