LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 3.0L - Crankshaft & Cylinder Block - Engine Code(S): CCBA, CGXC & CTUB (Sedan) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Belt Pulley Side >> Ribbed Belt, Removing And Installing >> Ribbed Belt, Removing And Installing, Vehicles With Hydraulic Power Steering >> Installing

Ribbed Belt, Removing And Installing, Vehicles With Hydraulic Power Steering: Installing

Fig 1: Placing Ribbed Belt Over Belt Pulley
GWWA13-10099Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Place the ribbed belt over the pulley as illustrated.

  1. Generator
  2. Idler roller
  3. Coolant pump
  4. Power steering pump
  5. A/C compressor
  6. Ribbed belt tensioner
  7. Vibration damper
NOTE:

When installing the ribbed belt, make sure it is seated correctly on the pulleys.

-- Start the engine and check the belt routing.

-- Install the supercharger ribbed belt. Refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals