Balance Shaft, Removing And Installing: Installing

Fig 1: Crankshaft Locking Pin T40069

Courtesy of AUDI OF AMERICA, LLC

Tightening specification: 60 Nm.
Crankshaft -1- secured in "Top Dead Center (TDC)" using Crankshaft Locking Pin T40069.

Install in reverse order of removal. Note the following:

NOTE:

The balance weights can only be positioned one way on balance shaft.

-- Install the power take-off drive chain. Refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .

-- Install the lower timing chain cover. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Install the belt pulley side sealing flange. Refer to SEALING FLANGE, REMOVING AND INSTALLING, BELT PULLEY SIDE .