General Information
The Testing Takes Place On A Test Stand.
When testing, manual transmission vehicles must be in idle and automatic transmission vehicles must be in driving position N.
Always observe the test stand manufacturer instructions.
NOTE:
Electronic Brake Control Systems Are Inoperative When The Ignition Is Switched Off.
If testing equipment is needed on road tests, follow the information below:
WARNING:
Distraction And Testing Equipment That Is Not Secured Properly Increase The Risk Of An Accident.
The passenger airbag could be dangerous if it deploys during an accident.
- Operating testing equipment while driving is a distraction.
- Testing equipment that is not secured probably increases the risk of injury.
- Position the passenger's seat as far back as possible.
- Only use the Vehicle Diagnostic Tester.
- Testing equipment -1- must lie flat on the passenger's lap as shown in the illustration and must only be operated by that passenger.