LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> Brakes >> Hose, Tubing, Fittings & Reservoirs >> Mechanical Components - Brake System (Cabriolet) >> 46 Mechanical Components >> Rear Brakes >> Brake Rotor, Removing And Installing >> Installing

Brake Rotor, Removing And Installing: Installing

Clean the brake rotor, wheel hub and contact surfaces before installing.

-- Place the brake rotor on the wheel hub.

NOTE:

When positioning the brake rotor, do not tilt it on the wheel hub.

-- Install the securing bolt -arrow- and tighten.

Fig 1: Identifying Brake Disc Secure Bolt
GWWA46-10018Courtesy of AUDI OF AMERICA, LLC

-- Install the brake caliper with brake carrier. Refer to BRAKE CALIPER, REMOVING AND INSTALLING .

-- Install the brake hose and electrical wire into the bracket on the stub axle carrier.

NOTE:

Make sure that the brake hose is clipped in and mounted correctly on the combination bracket on the stub axle carrier. This is so that the brake hose does not jump out of the bracket by itself.

-- Install The Wheels.

Wheel bolt tightening specification. Refer to WHEEL, CHANGING AND MOUNTINGWHEEL BOLT TIGHTENING SPECIFICATIONS .

-- Lower The Vehicle.

scientia non olet · About LEMON Manuals