Left/Right Parking Brake Motor -V282- / -V283-, Removing And Installing: Installing
-- Install New Seal.
-- Turn the brake caliper adjuster screw -1- back slightly.
This makes it easier to install the actuator.
-- Position the actuator.
Make sure that the seal is seated correctly
-- Item -2- Then rotate actuator so bolt hole -a- and threads in brake caliper housing -b- are brought into alignment.
Make sure that parking brake actuator is seated flush against the brake caliper.
-- Install both bolts on the actuator. Tightening Specification:12 Nm.
Always install the bolts a few turns by hand. If threads are damaged, the entire brake caliper must be replaced!
Only insert connector by hand to avoid damaging it.
Make sure that connectors on vehicle side and actuator side are free of dirt and damage.
-- Install connector.
-- Install The Wheels. Refer to WHEEL BOLT TIGHTENING SPECIFICATIONS / WHEEL, CHANGING AND MOUNTING .
After replacing the actuator, the basic setting must be performed with the vehicle diagnostic tester in the EPB function.
To do so, use the Vehicle Diagnostic Tester.
-- Connect the Vehicle Diagnostic Tester.
-- Then select under "Function" the corresponding functions.