Overview - Brake Pedal
WARNING:
The path of the brake pedal must not be shortened via extra floor mats.
- Lubricate all bearing and contact surfaces with Lubricating Grease:G 000 450 02
- 1 -Mounting Bracket for Pedal Assembly
- Illustration for vehicles with automatic transmission
- Removing and installing, vehicles with manual transmission. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .
- Removing and installing. vehicles with automatic transmission. Refer to MOUNTING BRACKET, REMOVING AND INSTALLING, VEHICLES WITH AUTOMATIC TRANSMISSION .
- 2 - Sleeve
- 3 - Brake Pedal Axle
- 4 - Mounting Pin
- 5 - Right Securing Clip (Spring Steel)
Parts Information.
- 6 - Washer
- 7 - Gas Pedal Module Bolt
- 8 Nm
- 8 - Accelerator Pedal Module
- 9 - Pedal Support Bolt
- 20 Nm
- 10 - Brake Lamp Sensor
- Removing and installing. Refer to BRAKE LAMP SENSOR, REMOVING AND INSTALLING .
- 11 - Mounting Pin Bolt
- 8 Nm
- The bolt holds the mounting pins in position
- 12 - Left Securing Clip (Spring Steel)
Parts Information.
- 13 - Brake Pedal
- Removing and Installing, with Manual Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH MANUAL TRANSMISSION .
- Removing and Installing, with Automatic Transmission. Refer to BRAKE PEDAL, REMOVING AND INSTALLING, VEHICLES WITH AUTOMATIC TRANSMISSION .WARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- 14 - Ball Socket Formed in Mount
- For the ball head on the brake booster push rod
- 15 - Mount
- For the ball head on the brake booster push rod
- With ball stud retaining tabs
- Removing and installing. Refer to BRAKE BOOSTER PLUNGER MOUNT, REMOVING AND INSTALLING .
- 16 - Nut
- 8 Nm
- 17 - StopWARNING:
If possible, leave the brake pedal stop installed; it could break the mount for the brake lamp sensor if the brake pedal is released too quickly.
- 18 - Grommet
- Only installed on vehicles with automatic transmission