Input Shaft Seal, Replacing

Special tools and workshop equipment required

-- Remove the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .

Fig 1: Removing/Installing Flywheel Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clutch release lever, release bearing and guide sleeve. Refer to CLUTCH RELEASE MECHANISM, SERVICING .

Fig 2: Removing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Pry out the input shaft seal.

-- Lightly oil outer circumference of new shaft seal for the input shaft.

Fig 3: Lightly Oil Outer Circumference Of New Shaft Seal For Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lip halfway with Sealing Grease G 052 128 A1.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Install the guide sleeve, clutch release lever and release bearing. Refer to CLUTCH RELEASE MECHANISM, SERVICING .

-- Install the clutch module. Refer to CLUTCH MODULE, REMOVING AND INSTALLING .