Input Shaft Ball Bearing, Replacing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Dual Clutch And Cover

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dual clutch -1-. Refer to DSG CLUTCH, REMOVING .

-- Remove the locking ring -arrow- from the removed clutch cover.

Fig 2: Identifying Locking Ring

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dual clutch ball bearing.

Fig 3: Pressing Out Dual Clutch Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

NOTE:

There may still be a thrust washer -2- behind the ball bearing -3- depending on the clutch cover date of manufacture. If there is, then replace the old one with a new one when installing the new ball bearing.

Fig 4: Identifying Dual Clutch Cover, Thrust Washer And Ball Bearing

Courtesy of AUDI OF AMERICA, LLC

Replace the ball bearing -3-.