Right Flange Shaft, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Secure the transmission on the Engine And Transmission Holder VAS6095. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.

Fig 1: Removing Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the Lifting Eyebolt 3368 into a threaded hole in the right flange shaft.

-- Position the Slide Hammer Set VW771 with the VW771/13 on the Lifting Eyebolt 3368 and remove the flange shaft.