Right Flange Shaft, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying Circlip

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

NOTE:

Replace the circlip on the right flange shaft.

-- Clamp the flange shaft in a vise with jaw protectors. Remove the old circlip from the groove in the flange shaft using the new circlip -A-.

-- Fill the space between the sealing- and dust lip half way with sealing grease.

-- Drive in the right flange shaft using the Bearing/Bushing Installer - Multiple Use VW295A.

-- Fill the transmission fluid (MTF). Refer to TRANSMISSION FLUID, DRAINING AND FILLING .