Sensor Module --, WITH INTEGRATED TRANSMITTERS AND SENSORS -G612-, -G632-, -G676 - AND Circuit Board 3 --, REMOVING AND INSTALLING: Notes

WARNING: This page is about a different variant/trim than selected.

CAUTION:

Caution:

Do not use the Hook And Support Tool T40197 for the following described work procedures - There is a risk of injury.

Only use the Hook and Support Tool T40294 for this operation.

Special tools and workshop equipment required

Hook and Support Tool T40294
Counterhold - Side Shaft T40217
Sensor Module Tool T40228
Sealant.

NOTE:

The Transmission Input Speed Sensor 2 -G612-, Transmission Input Speed Sensor 1 -G632-, Drive Position Sensor -G676- and Circuit Board 3 -- are integrated in the Sensor Module --. The components can only be replaced as a single Sensor Module -- unit.

Replace the wiring set for the sensor module (Refer to -item 39- Wiring Set) when replacing the Sensor Module (See Figure).