Flywheel, Removing And Installing: Removing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying T40176, Torque Converter -A-, And Nut -B-

Courtesy of AUDI OF AMERICA, LLC

Secure the transmission on the Engine And Transmission Holder VAS6095. Refer to SECURING ON ENGINE AND TRANSMISSION HOLDER .

-- Remove the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .

-- Attach the Puller - Clutch Module T40176 to the flywheel -A- with the nut -B- -arrow-.

-- Turn the Puller - Clutch Module T40176 upward.

Fig 2: Removing/Installing Flywheel Components

Courtesy of AUDI OF AMERICA, LLC

NOTE:

To prevent the flywheel from tilting, counterhold it underneath as illustrated.

-- Remove the flywheel from the input shaft -arrow-. Do not tilt the flywheel when doing this.