Flywheel, Removing And Installing: Installing

WARNING: This page is about a different variant/trim than selected.

Fig 1: Carefully Set Down Electro-Drive Drive Motor

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

-- Always clean the transmission housing in the area where the differential is accessed -arrow A- and the shaft seal -arrow B-.

NOTE:

Replace the shaft seal between the differential and transmission housing -arrow B- if it is damaged. Refer to LEFT SEAL, REPLACING .

-- Fill the space between the sealing- and dust lip half way with sealing grease.

-- Clean the input shaft -arrow-.

Fig 2: Identifying Input Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the input shaft splines using Grease for Clutch Disc Shaft Splines G 000 100.

-- Slide the clutch module onto the input shaft -arrow- carefully without tilting it.

Fig 3: Removing/Installing Flywheel Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Puller - Clutch Module T40176 from the flywheel -A-.

Fig 4: Identifying T40176, Torque Converter -A-, And Nut -B-

Courtesy of AUDI OF AMERICA, LLC

-- Install the left flange shaft. Refer to LEFT FLANGE SHAFT, REMOVING AND INSTALLING .