Shift Fork Group, Input Shaft, 1ST, 2ND And Reverse Gear Output Shafts Overview

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Shift Fork Group, Input Shaft, 1st, 2nd And Reverse Gear Output Shafts Overview

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 24 Nm
- Steel bolts (M8; 45 mm long)
- Quantity: 2
- For attaching the shift fork group, refer to item 2 in Fig 1 to the bearing bracket; Refer to item 3 in Fig 1
- Insert with locking fluid AMV 185 101 A1
Shift Fork Group
- Disassembling and assembling, refer to GEARSHIFT RAILS AND SELECTOR FORKS
Bearing Bracket
- Supports input shaft and input shaft in transmission cover
- Remove any locking compound still in the threaded holes with a thread cutter.
  NOTE:
  Outer roller bearing races on input and output shafts cannot be replaced individually.
  
  Roller bear outer races must not have any radial clearance in bearing bracket.
Input Shaft
- Disassembling and assembling, refer to INPUT SHAFT OVERVIEW
Output Shaft
- With 3rd and 4th gears
- 1st, 2nd and reverse gears, removing and installing, refer to SHIFT FORK GROUP, INPUT SHAFT, 1ST, 2ND AND REVERSE GEAR OUTPUT SHAFTS .
- Disassembling and assembling, refer to OUTPUT SHAFT
Thrust Washer
- For selector gear of 2nd gear
Inner Race/Needle Bearing
- For selector gear of 2nd gear
- Removing and installing, refer to item 26 in Figure
Needle Bearing
- For 2nd gear
2nd Gear Wheel
2nd Gear Inner Race
- Refer to item 23 in Figure
Intermediate Ring for 2nd Gear
- Refer to item 22 in Figure
Synchronizer Ring for 2nd Gear
- Refer to item 21 in Figure
Locking Collar/Synchronizer Hub for 1st and 2nd Gears
- Refer to item 20 in Figure
Inner Race/Needle Bearing
- For the 1st gear selector gear
- Removing and installing, refer to item 19 in Figure
Needle Bearing
- For 1st gear
Synchronizer Ring for 1st Gear
- Refer to item 17 in Figure
Intermediate Ring for 1st Gear
- Refer to item 16 in Figure
1st Gear Inner Race
- Refer to item 15 in Figure
1st Gear Wheel
Thrust Washer
- For 1st gear and reverse gear selector gears
Inner Race/Needle Bearing
- For reverse gear
- Removing and installing, refer to item 12 in Figure
Needle Bearing
- For reverse gear
Reverse Gear Wheel
- With reverse gear locking collar
- Refer to item 9 in Figure
Synchronizer Ring for Reverse Gear
- Refer to item 8 in Figure
Reverse Gear Intermediate Ring
- Refer to item 7 in Figure
Reverse Gear Inner Race
- Refer to item 6 in Figure
Reverse Gear Synchronizer Hub
- Can be manually removed from the output shaft
Thrust Washer