Release Bearing With Pressure Ring -1- From February 2008
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- The pressure ring for the release bearing -1- may have axial and radial play.
- The pressure ring -1- can tip on all sides inside the release bearing -3-.
- If the running surface -arrow 2- on pressure ring -1- is worn deeper than 0.8 mm, the release bearing -3- must be replaced.
- The pressure ring is almost loose when the release bearing is not touching the clutch.