Fuel delivery unit, removing and installing: Removing

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Observe safety precautions → Safety precautions when working on fuel supply system .

Observe rules for cleanliness → Rules for cleanliness .

CAUTION:

To remove the fuel delivery unit, the fuel tank may only be filled to a maximum of ¹ /₄ . Drain fuel tank if necessary. Procedure → Fuel tank, draining .
Observe procedures for disconnecting battery →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
.

All except Audi RS4:

Fig 1: Pushing Cover Over Battery Toward Right And Removing It Upward

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Push cover over battery toward right - arrow 1 - and remove it upward - arrow 2 -.

Fig 2: Locating Battery Ground Strap

Courtesy of VOLKSWAGEN UNITED STATES, INC.

With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.

Audi RS4:

Raise luggage compartment floor covering and secure.

Fig 3: Disconnecting Battery Ground (GND) Strap

Courtesy of VOLKSWAGEN UNITED STATES, INC.

With ignition switched off, disconnect Battery Ground (GND) strap - arrow -.

All:

Open fuel filler flap briefly and then close again.
Remove rear seat bench →
- 72 - SEAT - FRAMES
- 72 - SEAT - FRAMES for BODY INTERIOR - CABRIOLET
.

Fig 4: Removing Cover Bolts For Locking Flange

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Unbolt cover for right locking flange - arrows -.

Audi RS4:

Fig 5: Removing Electrical Wires With Connector From Locking Flange Opening

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Free up electrical connector - arrow - for Fuel Pump (FP) Control Module J538 and disconnect.

All:

Fig 6: Disconnecting Electrical Harness Connector At Right Locking Flange

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect electrical harness connector - arrow - at right locking flange.

Fig 7: Identifying Fuel Return Line And Fuel Supply Line

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Mark fuel return line - 1 - and fuel supply line - 2 -.

CAUTION: The fuel system is under pressure! Before opening system, place rags around the connection area. Then release pressure by carefully loosening the connection.

Pull both lines from locking flange, by pressing release buttons.

CAUTION: Locking flange may only be opened when fuel tank is maximum ¹ /₄ full. Otherwise, a large amount of fuel will spill out.

Fig 8: Removing/Installing Locking Ring With Wrench T10202

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove locking ring using wrench T10202.
Remove locking flange and seal from opening in fuel tank and lay aside locking flange with lines still connected.

Fig 9: Identifying Suction Jet Pipe & Fuel Delivery Line

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Disconnect suction jet pipe - 1 - to suction jet pump by pressing release button.
Disengage fuel delivery line - 2 -.
Remove fuel delivery unit.

NOTE:

When removing fuel delivery unit, be sure not to bend floater arm of Fuel Level Sensor G.
Be aware that fuel is still in the fuel delivery unit.