Clutch Slave Cylinder, Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order of removal while observing the following:
NOTE:
If damaged, replace the O-ring.
If clutch slave cylinder is guided on at an angle, there is the danger that the plunger may be guided past the clutch release lever.
-- Preload the clutch slave cylinder -1- enough that the mounting bolt -3- can be inserted easily. Tightening specification CLUTCH HYDRAULICS OVERVIEW .
-- Press the clip -2- all the way in.
-- Insert the line into the clutch slave cylinder until it engages.
-- Pull on the hose/line assembly to make sure it is secure.
-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .
-- Install the rear noise insulation. Refer to NOISE INSULATION .