Clutch Slave Cylinder: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Noise Insulation

Courtesy of AUDI OF AMERICA, LLC

-- Clutch master or slave cylinder, removal and installation information. Refer to CLUTCH MASTER OR SLAVE CYLINDER INFORMATION .

NOTE:

Brake fluid must not come into contact with the transmission. Clean the transmission housing if necessary.

-- If equipped, remove rear noise insulation -2-. Refer to OVERVIEW - NOISE INSULATION .

Fig 2: Identifying Clutch Slave Cylinder

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Danger of eye injury.

Wear protective eyewear.

-- Open the clip -2- with a screwdriver and pull it out.

-- Remove the hose/line assembly from the clutch slave cylinder and seal it.

-- Remove the bolt -3- and remove the clutch slave cylinder -1- toward the rear.

NOTE:

To prevent dirt from getting in, seal any open lines and connections with a clean plug taken from the VAS 6122.