Clutch Slave Cylinder, Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
NOTE:
If damaged, replace the O-ring.
If the clutch slave cylinder is guided on at an angle, there is the danger that the plunger may be guided past the clutch release lever.
-- Preload the clutch slave cylinder -1- enough that the mounting bolt -3- can be inserted easily. Tightening specification -item 17- 17.
-- Press the clip -2- all the way in.
-- Push the hose/line assembly into the clutch slave cylinder until assembly audibly engages.
-- Pull on the hose/line assembly to make sure it is secure.
-- Bleed the clutch system. Refer to CLUTCH SYSTEM, BLEEDING .
-- Install the rear noise insulation, if equipped. Refer to OVERVIEW - NOISE INSULATION .