Clutch Pedal Assembly Overview
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2016 Audi S5, 2015 Audi S5, 2014 Audi S5, 2013 Audi A5, and 2012 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Risk of accident!
- The amount of brake pedal travel must not be decreased by additional floor mats.
NOTE:
Lubricate the various bearing and contact surfaces with grease G 000 450 02.
Make sure that no brake fluid escapes into the footwell or into the plenum chamber or onto the transmission below. If it does, clean the area thoroughly.
- Bracket
- With the brake pedal
- Removing and installing, refer to the appropriate service information .
- Bearing Bushing
- Clutch Pedal
- Removing and installing, refer to CLUTCH MASTER CYLINDER .
- Clutch Pedal Stop
- Mounting Pins
- For the clutch master cylinder
- Lubricate the bearing area
- Clutch Pedal Mounting Axle
- Lubricate the bearing area
- Bearing Shell
- Located in the clutch pedal
- Over-Center Spring
- Black side faces toward clutch pedal
- Note the different bearing position in the mounting bracket OVER-CENTER SPRING .
- Removing and installing, refer to OVER-CENTER SPRING .
- Bearing Shell
- Note the different bearing position in the mounting bracket OVER-CENTER SPRING .
- Gasket
- Replace
- Clutch Master Cylinder
- Removing and installing, refer to CLUTCH MASTER CYLINDER .
- Lubricating the bearing lug for the pressure rod.
- Clutch Position Sensor -G476-
- Integrated clutch pedal switch -F36- and clutch pedal starter interlock switch -F194-
- Can only be replaced together with the master cylinder -item 11- 11