Input Shaft Seal, A5 Coupe From My 2008, Through Transmission Series Number 000760, Replacing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 Audi S5, 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, and 2009 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Transmission with these transmissions series numbers were installed only in the Audi A5 Coupe from MY 2008.

Special tools and workshop equipment required

Pulling Hook T20143/1
Assembly Tool T10122
Press Tool for Shaft Seal T10184
Sealing grease G 052 128 A1

Transmission is removed, refer to [For engine(s) CAUA] Removal and Installation .

-- Remove the clutch module. Refer to CLUTCH MODULE .

-- Pry out the input shaft seal.

Fig 1: Removing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Lightly coat the outer circumference of the new shaft seal with oil.

Fig 2: Installing Input Shaft Seal

Courtesy of AUDI OF AMERICA, LLC

-- Fill the space between the sealing and dust lip half way with sealing grease G 052 128 A1.

-- Drive the new seal in until it is flush without tilting it.

-- Install the clutch module. Refer to INSTALLING .