LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 651 (Seat Upholstery & Covers) >> 74 Seat Upholstery, Covers >> Rear Seat Covers And Cushions >> Headrest Cover And Cushion, Removing And Installing >> Installing

Headrest Cover And Cushion, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

-- Install the cover -3-.

-- Position the cover and slide it correctly over the support with cushion.

-- Close the zipper while installing the upper flat channel -1-.

-- Push the edge of the cover with the flat channel into the U-channel -3-.

-- After closing the zipper with a needle or pointed tool, line up the cover the strip.

-- Make sure the cover lies on the upholstery without any wrinkles and without seam markings.

Install in reverse order of removal.

scientia non olet · About LEMON Manuals