HYDRAULIC PULSE MEMORY WITH Accumulator Solenoid -N485-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specifications, refer to OVERVIEW - ATF SYSTEM .

NOTE:

Replace the O-ring and the bolts from the hydraulic pulse memory.

-- Install the hydraulic pulse memory -A- with a new O-ring -D-.

-- Tighten the bolt in the following sequence: -1 to 3-.

-- Disconnect the connector -B- for the hydraulic pulse memory -A- carefully.

NOTE:

Make sure the connector locks and is secure.

-- Route the wire -C- according to the illustration and secure it -arrows-.

-- Install the ATF filter, refer to ATF FILTER, REMOVING AND INSTALLING .

-- Install the ATF pan, refer to OIL PAN, REMOVING AND INSTALLING .

-- Fill the ATF, refer to ATF LEVEL, CHECKING .