Transmission Fluid Auxiliary Hydraulic Pump Wiring Harness, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Transmission Fluid Auxiliary Hydraulic Pump Wiring Harness (Mark Connectors)

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note the following:

If the previous wiring harness -1- is to be reinstalled, then replace the O-ring on the connector -4-.

Installed position of the connector -4- : Insert with the straight surfaces at the housing ribs -5- as shown in the illustration.

-- Press the lock washer -A- onto the connector -B- for the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475- wiring harness opposite the direction of the -arrow- and secure it.

Fig 2: Identifying Wiring Harness Connector -B- And Lock Washer -A-

Courtesy of AUDI OF AMERICA, LLC

-- Press the connectors -2 and 3-, marked similar to the removal, into the transmission housing openings.

-- Install the Mechatronic, refer to MECHATRONIC, REMOVING AND INSTALLING .

Install the Transmission Fluid Auxiliary Hydraulic Pump 1 -V475-, refer to TRANSMISSION FLUID AUXILIARY HYDRAULIC PUMP, REMOVING AND INSTALLING .

-- Install the ATF filter, refer to ATF FILTER, REMOVING AND INSTALLING .

-- Install the ATF pan, refer to OIL PAN, REMOVING AND INSTALLING .

-- Fill the ATF, refer to ATF, DRAINING AND FILLING .