Turbocharger, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the seals, O-rings and the self-locking nuts.

Fill the turbocharger with engine oil at the connection for oil supply line.

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

-- Install the right engine mount, refer to OVERVIEW - SUBFRAME, ENGINE MOUNT .

-- Install the catalytic converter, refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, NON-HYBRID VEHICLES .

-- Install the air filter housing, refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the air guide hose, refer to OVERVIEW - CHARGE AIR SYSTEM .

-- Install the engine cover, refer to ENGINE COVER, REMOVING AND INSTALLING .

NOTE:

Do not reuse used coolant.

-- Fill the coolant pump, refer to COOLANT, DRAINING AND FILLING, NON-HYBRID VEHICLES => Filling or COOLANT, DRAINING AND FILLING, HYBRID VEHICLES => Filling .

-- Check the oil level. Refer to ENGINE OIL LEVEL, FILLING AND CHECKING .

NOTE:

After installing turbocharger, let engine idle for approximately 1 minute without increasing engine speed. This ensures adequate oil supply to the turbocharger.