LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 633 (2.0L - Turbocharger & Supercharger - Engine Code(S): CAEB, CHJA, CPMA & CPMB) >> 21 Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Charge Air Cooler, Removing And Installing, Hybrid Vehicles >> Installing

Charge Air Cooler, Removing And Installing, Hybrid Vehicles: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

If there are small impressions on the fins, refer to COOLER AND CONDENSER ASSEMBLY .

The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.

Secure all hose connections with hose clamps of the same type as those equipped by the factory .

In order to be able to securely mount the air guide hoses on their connectors, spray the screws on the previously used clamps with a rust remover.

-- Install the air guide hose, refer to OVERVIEW - CHARGE AIR SYSTEM .

-- Install the impact member, refer to IMPACT MEMBER, REMOVING AND INSTALLING .

Tightening specifications 

scientia non olet · About LEMON Manuals