Overview - Camshaft Timing Chains
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2017 Audi Q5, 2016 Audi Q5, 2015 Audi Q5, 2014 Audi Q5, and 2013 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening specification: 9 Nm
- Chain Tensioner
- Is under tension
- Remove the Locking Pin T40011 before removing
- Timing Chain Tensioning Rail
- Guide Pin
- Tightening specification: 20 Nm
- Bolt
- Tightening specification: 9 Nm
- Control Valve
- Tightening specification: 35 Nm
- Left thread
- Remove using Central Valve Assembly Tool T10352
- Bolt
- Tightening specification: 20 Nm + 90° turn
- Replacing
- Washer
- Bearing Bracket
- Camshaft Timing Chain Glide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint
- Removing and installing, refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Camshaft Timing Chain Glide Rail
- Guide Pin
- Tightening specification: 20 Nm
- Three Stage Chain Sprocket
- Crankshaft
- Installed position, refer to Fig 2
- Both surfaces must -arrows- must line up across from each other.