Camshaft, Measuring Axial Clearance

WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Dial Gauge Holder VW387
Dial Gauge - 0-3mm VW6080

Procedure

Fig 1: Securing Dial Gauge Holder VW 387 To Dial Gauge VAS 6080 On Cylinder Head

Courtesy of AUDI OF AMERICA, LLC

-- Remove the camshafts, refer to CAMSHAFT, REMOVING AND INSTALLING .

-- Mark the allocation of the roller rocker lever and the hydraulic adjusting elements so they can be installed again.

-- If necessary, remove the roller rocker levers with the hydraulic adjusting elements and place them on a clean surface.

-- Secure the Dial Gauge Holder VW387with the Dial Gauge - 0-10mm VW6079 on the cylinder head ash shown in the illustration.

-- Determine the axial play.

Axial play: 0.100 to 0.191 mm.