Overview - Balance Shaft And Oil Pump Drive Chain
WARNING: This page is about a different car, the 2012 Audi Q5, 2011 Audi Q5, 2010 Audi Q5, and 2009 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft
- Power Take-Off Drive Chain
- Before removing, mark the direction of rotation with paint
- Removing and installing, refer to POWER TAKE-OFF DRIVE CHAIN, REMOVING AND INSTALLING .
- Drive Sprocket for Oil Pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm + 90° turn
- Replace
- Pressure Spring
- Bolt
- 15 Nm + 90° turn
- Replace
- Balance Shaft Chain Sprocket
- Installed position: the side with lettering on it faces the transmission
- Chain Tensioner
- With glide track
- Bolt
- 10 Nm + 45° turn
- Replace