Supercharger, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
- Tightening specification, refer to OVERVIEW - SUPERCHARGER .
NOTE:
Replace the seals
The hose connections as well as the air guide pipes and hoses must be free of oil and grease before installing.
Secure all hose connections with hose clamps of the same type as those equipped by the factory .
To mount the air guide hoses on their connectors securely, spray the bolts on the used clamps with rust remover before installing.
-- Make sure the crankcase ventilation support is installed correctly when mounting the supercharger.
- - Install the crankcase ventilation connector -1- with new O-rings into the oil separator cover.
- * Installed position: the tab -2- must engage into the guide -arrow-.
-- Install the air guide pipe, refer to OVERVIEW - AIR FILTER HOUSING .
-- Install the supercharger ribbed belt, refer to SUPERCHARGER RIBBED BELT, REMOVING AND INSTALLING .
-- Fill the coolant, refer to COOLANT, DRAINING AND FILLING .