Tightening Specifications, Tightening Sequence

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2017 Audi SQ5, 2017 Audi Q5, 2016 Audi SQ5, 2016 Audi Q5, and 2015 Audi SQ5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Valve Control Module & Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts -arrows- to 10 Nm in a diagonal sequence.

Fig 2: Control Valve Control Unit -J808- and Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts in three steps as follows:

Step	Bolts	Tightening Specification
1	5 and 6	Install all the way in by hand
2	6	10 Nm
3	5	10 Nm

Fig 3: Identifying Connector And IAT Sensor/MAP Sensor Bolts

Courtesy of AUDI OF AMERICA, LLC

Tighten the bolts -arrows- to 10 Nm.

Fig 4: Installing Crankcase Ventilation Connector

Courtesy of AUDI OF AMERICA, LLC

- Install the crankcase ventilation connector -1- with new Orings into the oil separator cover.

* Installed position: the tab -2- must engage into the guide -arrow-.