Gear Oil, Draining And Filling, Front Final Drive, Transmission With Separated Oil System: Filling
- Gear oil temperature: approximately 20 °C (68 °F) (room temperature).
-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.
Danger of eye injury.
- Wear protective eyewear.
-- Remove the drain plug -arrow A- from the front final drive.
-- Install the Pressurized Gearbox Oil Filler - Adapter 6 VAS6617/6 with Pressurized Gearbox Oil Filler - Adapter 2 VAS6617/2 in the transmission hand tight.
-- Connect the Pressurized Gearbox Oil Filler Kit VAS6617 and fill the front final drive with approximately 0.9 liters of gear oil.
- Gear oil specification, allocate correct fluid.
-- Wait five minutes.
A filling time of at least five minutes is required so that the internal oil level between the differential and oil fill space can equalize.
-- Remove the Pressurized Gearbox Oil Filler - Adapter 6 VAS6617/6 from the transmission and let any extra oil drain out.
- Specified value: The oil level is correct when the front final drive is filled up to bottom edge of oil filler hole. Fill the gear oil once more if necessary.
-- Tighten the new drain plug -arrow A- for the front final drive.
It is not necessary to check the oil level again at this stage.