Gear Oil, Draining And Filling, Front Final Drive
Special tools and workshop equipment required
- Used Oil Collection and Extraction Unit SMN372500
- Pressurized Gearbox Oil Filler Kit VAS6617
- Protective eyewear
Draining
- The engine is off.
- Move the vehicle onto a four-column workshop hoist or over a work pit so it is completely level.
- Gear oil temperature: approximately 20 °C (68 °F) (room temperature).
- Tightening specifications, refer to OVERVIEW - TRANSMISSION DRAIN AND INSPECTION PLUG FOR GEAR OIL .
General repair instructions, refer to GENERAL REPAIR INFORMATION .
Clean working conditions for the automatic transmission, refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .
Follow the disposal requirements.
Replace the ATF drain plug and seal.
Replace the plug for the ATF check and fill hole.
-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.
Danger of eye injury.
- Wear protective eyewear.
-- Remove the drain plug -arrow B- from the front final drive and drain the transmission fluid.
Danger of causing damage to the transmission.
- Do not start the engine if there is no transmission oil in the front final drive.
-- Install the new drain plug -arrow B-.
Filling
- Gear oil temperature: approximately 20 °C (68 °F) (room temperature).
- Tightening specification, refer to OVERVIEW - TRANSMISSION DRAIN AND INSPECTION PLUG FOR GEAR OIL .
-- Place the Used Oil Collection and Extraction Unit SMN372500 under the transmission.
Danger of eye injury.
- Wear protective eyewear.
-- Remove the drain plug -arrow A- from the front final drive.
-- Install the Pressurized Gearbox Oil Filler - Adapter 6 VAS6617/6 with Pressurized Gearbox Oil Filler - Adapter 2 VAS6617/2 in the transmission hand tight.
-- Connect the Pressurized Gearbox Oil Filler Kit VAS6617 and fill the front final drive with approximately 0.9 liters (0.95 quarts) of gear oil.
- Transmission fluid, allocate correct fluid.
-- Wait five minutes.
A filling time of at least five minutes is required so that the internal oil level between the differential and oil fill space can equalize.
-- Remove the Pressurized Gearbox Oil Filler - Adapter 6 VAS6617/6 from the transmission and let any extra oil drain out.
- Specified value: the oil level is correct when the front final drive is filled to the lower edge of the filler hole. If needed, fill the gear oil again.
-- Tighten the new drain plug -arrow A- for the front final drive.
It is not necessary to check the oil level again at this stage.