Overview - Oil Pan/Oil Pump, Oil Pan Lower Section And Oil Pump
WARNING: This page is about a different car, the 2016 Audi Q5, 2015 Audi Q5, and 2014 Audi Q5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If large quantities of metal shavings or abraded material are found in the engine oil while servicing the engine, the oil passages must be carefully cleaned to prevent resulting damage and the engine oil cooler must be replaced.
Oil injector jet for piston cooling, refer to Fig 1.
- Oil Level Thermal Sensor -G266-
- Removing and installing, refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace
- Bolt
- Replace
- Tightening specification and sequence, -1 to 15- Tighten an additional 90°.
- Oil Pan Lower Section
- Removing and installing, refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Bolt
- 3 Nm + an additional 90° turn
- Replace
- Oil Baffle
- Bolt
- 9 Nm
- Intake Line
- Bolt
- 9 Nm
- O-Ring
- Replace
- Bolt
- Replace
- Tightening specification and sequence, refer to Fig 4.
- Oil Pump
- With brake booster vacuum pump
- Do not disassemble
- Removing and installing, refer to OIL PUMP, REMOVING AND INSTALLING .
- O-Ring
- Replace
- Alignment Sleeves
- Quantity: 2
- Input Shaft
- For the oil pump
- Pressure Spring
- Yoke
- Chain Sprocket
- For the oil pump
- Installed position: the side with lettering on it faces the engine
- Bolt
- 30 Nm + an additional 45° turn
- Replace
- To loosen, counterhold on sprocket with Wrench - Pin Type 3212.
- If it is not possible to tighten the bolt to the specification, remove the oil pan lower section and the oil baffle and counterhold the bolt with an open end wrench on the oil pump driveshaft.
- Bolt
- 9 Nm
- Oil Return Pipe
- Seal
- Replace
- Oil Drain Plug
- 30 Nm
- Bolt
- 9 Nm
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten the bolts in three steps and in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 15- | 2 Nm |
| 2. | -1 to 15- | 3 Nm |
| 3. | -1 to 15- | Tighten an additional 90° |
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten the bolts in three steps and in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 to 3- | Install all the way in by hand. |
| 2. | -1 to 3- | 8 Nm |
| 3. | -1 to 3- | Tighten an additional 90° |