Camshafts, Removing, Used Camshafts, Reinstalling On Cylinder Bank 2, Left: Removing

Fig 1: Crankshaft Holder 3242

Courtesy of AUDI OF AMERICA, LLC

-- Remove the camshaft timing chain for the intake camshaft, refer to CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .

• Secure crankshaft -1- in "TDC" position using Locking Pin For Crankshaft T40237.

-- Check the camshaft "TDC" position:

Fig 2: Identifying Intake Camshaft And Exhaust Camshaft

Courtesy of AUDI OF AMERICA, LLC

• The intake camshaft -2- must be able to be stopped with the Camshaft Adjustment Pins T40060.
• The bolt -arrow- in the Camshaft Adjustment Pins T40060 must be perpendicular to the center axis of the camshaft.
• The exhaust camshaft -1- must be positioned so that the groove -arrow B- runs parallel above the joint -arrow A- between the thrust bearing and the bearing cap.

-- Mount the Camshaft Fitting Tool - T40096 T40096 onto the teeth of the intake camshaft so that one arm of the clamping tool engages in one sprocket half.

Fig 3: Identifying Camshaft Fitting Tool

Courtesy of AUDI OF AMERICA, LLC

• The wider arm must engage into the wider half of the sprocket.

-- Tension the tensioning tool with the thumb wheel until the tooth faces align.

-- Loop a cable tie -arrows- on the right and left around the thrust bearing and the bearing cap and tighten them.

Fig 4: Identifying Cable Ties

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the bearing cap bolts in the following sequence: -12 to 1-.

Fig 5: Cylinder Bank 2 (Left) Bearing Cap - Loosening And Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove the bearing cap with the camshafts.